? 2012 tyco electronics corporation, a te connectivity ltd. company ? all rights reserved *trademark te connectivity, te connectivit y (logo), and te (logo) are trademarks. other logos, product and/or company names may be tradem arks of their respective owners. 1 of 2 instruction sheet tooling assistance center 1-800-722- 1111 ? product information 1-800-522-6752 this controlled document is subject to change. ? for latest revision and regional customer service, visit our website at www.te.com 408-7678 ? extraction tool 91104-1 ? for locking clip contacts 10 apr 12 rev a 1. introduction dimensions in this instruction sheet are in metric units [with u.s. customary units in brackets]. figures are not drawn to scale. note i extraction tool 91104-1 is designed to remove a locking clip contact from a .031x.062-in. printed circuit (pc) board post or a locking clip connector (for .031x.062-in. posts). see figure 1 . read these instructions thoroughly before extracting any contacts. reasons for reissue of this instruction sheet are provided in section 6, revision summary. 2. description this tool features a handle and a hooked tip for extracting a contact from a post and a tapered tip ? for extracting a contact from a connector. 3. extraction ! caution 3.1. from posts (see figure 1, detail a) 1. align the hooked tip with the contact. . 2. position the hooks under the contact spring, and hold the wire against the tool. 3. keeping the tool para llel with the contact, pull straight up on the tool and wire. the contact should extract easily. the tool must be kept parallel with the contact being removed; otherwise, damage to the tool, contact, and/or p ost may result. ? ! caution 3.2. from connectors (see figure 1, detail b) the connector must be removed from the posts before using the extraction tool. ? ? detail b keep tool parallel to contact hold wire against tool hooks of tool tip contact spring posts pc board contact locking lance wire of contact to be removed tapered side of tool tip connectors removed from posts posts on pc board tool slot 1. align the tapered tip with the applicable tool slot located on either side of the connector. make sure that the tapered side of the tool tip is facing the contact to be removed. 2. insert the tool thro ugh the connector until it bottoms. the locking lance of the contact to be removed should now be released. 3. grip the wire of the contact to be removed, and pull the contact straight out of the connector. the contact should extract easily. 4. remove the tool. figure 1 detail a
408-7678 2 of 2 rev a 4. maintenance and inspection the extraction tool should be inspected against the information in figure 2 . it is recommended that the tool be inspected immediately upon arrival, and at r egularly scheduled intervals, to ensure that the tool is not defective or damaged. 5. replacement and repair order extraction tools through your representative, or call 1-800-526-5142, or send a facsimile of your purchase order to 1-717-986-7605, or write to: customer service (038-035) ? tyco electronics corporation ? po box 3608 ? harrisburg pa 17105-3608 6. revision summary revisions to this instruction sheet include: ? changed company name and logo ? replaced address in section 5 911094-1 126 mm [4.96 in.] 2.24 mm [.088 in.] 2.24 mm [.088 in.] 2.16 mm [.085 in.] 1.73 mm [.068 in.] 4.01 mm [.158 in.] figure 2
|
